Loading ...
Loading ...
Loading ...
5
Installation
Pullout Freezer Drawer
(select models)
To avoid electrical shock which can cause severe
personal injury or death, disconnect power to
refrigerator before removing doors. After replacing
doors, connect power.
WARNING
To prevent accidental child entrapment or
suffocation risk, do not remove the divider in the top
freezer basket.
DANGER
To avoid possible injury, product, or property
damage, you will need two people to perform the
following instructions.
CAUTION
2. While supporting door front,
hook supports into tabs
located on inside of rail.
To Install:
1. Pull both rails out to full
extension.
3. Lower door front into
final position.
4. Replace and tighten Phillips screws that were
removed from each side of rail system (select
models).
5. Place the basket cradles back onto the side rails.
Align snaps with the slots on the side rails and
press each snap towards the rail until it clicks.
6. With rails pulled out to full extension, set the
basket straight down into the basket cradles.
7. Slide upper basket into freezer. Make sure that rear
of basket hooks behind rail catch.
Basket cradle
snap attachments
6. Lift top of drawer front
to unhook supports
from rail system. Lift
door front out to
remove.
To Remove:
1. Pull drawer open to full extension.
2. Pull upper basket out to full extension and lift out
to remove.
3. Lift lower basket straight up and out to remove.
4. On each side rail is a
basket cradle with two snap
attachments. To release
each cradle, unlatch the
snaps by pushing them
inward, away from the side
rail system. Lift the cradles
off of the rails.
5. Remove Phillips screw
from each side of rail
system (select models).
Loading ...
Loading ...
Loading ...