Loading ...
Loading ...
Loading ...
7
8
ENGLISH
ENGLISH
PAIRING & DISCOVERING A NEW BLUETOOTH CONNECTION
1) Power on the MC900B by pressing and holding down the Power
2
button for 2
seconds, the Bluetooth blue LED will start to ash, and a conrmation tone will be heard
from the speakers signalling that the MC900B is now ready for Bluetooth pairing.
NOTE: You have 2 minutes before you must restart this procedure over again.
2) Now that the MC900B is in pairing mode:
ANDROID users:
a. Go into the Settings Menu of your device
b. Enter the Bluetooth Menu and press SCAN
c. “MC900B” will now be display under AVAILABLE DEVICES
d. If prompted, enter passcode: “0000”
iOS users:
a. Go into the Settings Menu of your iOS device
b. Enter the Bluetooth Menu
c. “MC900B” will now be displayed
d. If prompted, enter passcode: “0000”
3) If the MC900B is not seen, repeat the above steps to refresh the “Device List”
4) When the connection is successful you will hear a conrmation tone, you are now ready
to stream music from your devices favorite media player to the MC900B
BLUETOOTH OPERATION
2
Tips:
EN
Nyne Cruiser
USB CHARGE
5V 1A
Tips:
EN
Nyne Cruiser
USB CHARGE
5V 1A
To avoid battery exhaustion be sure to run the vehicles engine
while using this product. Using this product without running the
engine can drain the battery.
Tips:
EN
Nyne Cruiser
USB CHARGE
5V 1A
BLUETOOTH OPERATION
RECONNECTION
1) Power on the MC900B and your last paired device Bluetooth.
2) The unit will now automatically reconnect, and a conrmation tone will be heard from the
speakers
3) If your device was previously paired with the BOSS AUDIO MC900B, but it wasn’t the
last paired device:
a. Ensure no other devices are currently paired
b. Enter the Bluetooth Menu on your device being paired
c. “MC900B” will display under AVAILABLE DEVICES
d. Choose the “MC900B” to reconnect
4) If the device is out of range from the MC900B, it will disconnect automatically:
a. To reconnect once device is back in range, press the Power
2
button once
b. The MC900B will now reconnect to the device, a conrmation tone will be heard
from the speakers
CLEARING PREVIOUSLY PAIRED DEVICES MEMORY
1) Quick press the POWER
2
button 2X, all BLUE LED’s will start to ash
2) Press and hold the PLAY/PAUSE
5
button for 10 seconds, a conrmation tone from
the speakers will be heard, the LED’s will stop ashing, now only the BT LED will ash
3) PAIR a new device as described on PG 8
2
Tips:
EN
Nyne Cruiser
USB CHARGE
5V 1A
Tips:
EN
Nyne Cruiser
USB CHARGE
5V 1A
5
Loading ...
Loading ...