Loading ...
Loading ...
- 3 -
• Draw the pulling part of air filter into front side of your hand while holding it to upside.
• How to attach is in reverse order of how to detach.
• As for cleaning method of air filter, refer to Installation manual of main body of the inside air
conditioner.
• Don't pull Elevation grille for sake of safety.
Or else there is worry about injury by dropping out of clip at end of wire.
And don't raise Elevation grille under condition when it has been dragged off.
Or else there is worry about wire getting wound up or getting damaged.
• If raising under condition where air filter has not been perfectly attached, it may cause trouble that
Installation manual is not inserted.
So firmly affix air filter.
➀
Detach air filter.
➁
Remove contaminants by soaking a soft cloth or cotton in water dissolved with neutral
detergent.
1. Auto leveling function
– When the grille is tilted while it is operating, this function levels the grille in front, rear, left
and right direction
2. Drop distance setting function
– If drop height is more than 1M,this function blocks the grille from falling below a drop
height limit set by the user. When the grill is falling, press the ( ■ ) button at the height you
want. When the grill stops, press the ( ■ ) button 3 times. The grille will not fall below the
designated height for future operations.
3. Floor detection function
– When the grille hits an obstacle during the drop, this function will detect the height from
the floor and lift and stop the grille at 100mm above the location where it hit the obstacle.
4. Lift stop function
– If the panel is tilted when the grille is lifted and inserted to the panel, it will drop again to
reinsert to the panel. (Repeated up to 2 times.)
How to Detach/Attach Filter
How to Clean the Elevation grille
Main Fucntion
Loading ...