Loading ...
Loading ...
Loading ...
Black plate (207,1)
北米Model "A2530BE-B" EDITED: 2016/ 7/ 27
Malfunction of the high beam assist
function:
High beam assist warning indicator (yel-
low)
When the high be am assist function
malfunctions, the high beam assist warn-
ing indicator on the combination meter will
appear. In this case, have your vehicle
inspected by your SUBARU dealer.
Temporary stop of high beam assist
function:
If the high beam assist function stops
temporarily due to poor visibility or abnor-
mal temperature, the message appears
on the combination meter. When the
condition is canceled, the system will be
restored.
NOTE
Even when the operation conditions of
the high beam assist function are met,
there may be a case in which the high
beam assist indicator does not illumi-
nate and an abnormal condition warn-
ing is given. In th is case, turn the
ignition switch to the “LOCK”/“OFF”
position and then the “ON” position
again. Check if the high beam assist
indicator illuminates. If the indicator
does not illuminate, have the vehicle
inspected at a SUBARU dealer.
! How to tempora rily lower the
sensitivity of the high beam
assist function
The sensitivity of the high beam assist
function can be lowered by using the
following operations.
1. Turn the ignition switch to the “ON”
position.
1) Automatic dimming on/off button
2. Press and hold the automatic dimming
on/off button for 15 to 20 seconds.
When the sensitivity of the high beam
assist function is lowered, the LED in-
dicator on the automatic dimming on/off
button will flash.
NOTE
. The sensitivity of the high beam
assist function cannot be lowered
while driving.
. You can resume the sensitivity of
the high beam assist function by using
either of the following operations.
– Turn the ignition switch to the
“LOCK” /“OFF” posit ion and then
start the engine.
Instruments and controls/Light control switch
– CONTINUED –
3-51
3
Loading ...
Loading ...
Loading ...