Loading ...
Loading ...
Loading ...
IR Sensor
The remote control of the TV uses RF (radio frequency) to
send its commands to the TV. With RF, you do not need to
point the remote control at the TV.
However, the TV can also receive commands from a remote
control that uses IR (infrared) to send commands. If you use
such a remote control, always make sure you point the remote
control at the infrared sensor on the front of the TV.
Pairing
This remote control uses radio frequency (RF) to send its
commands to the TV. Contrary to remote controls using
infrared signals, with this remote control you can send
commands without pointing at the TV.
With no need to point the remote control, using the keyboard
on the back or sending commands from another room -
changing the volume or switching channels - is easy.
Additionally, the TV can notify you when the battery power of
the remote control is low.
Pairing the remote control
For the remote control to communicate with the TV, both TV
and remote control should be paired with each other. Once
paired, you cannot use the remote control to control another
TV.
When you started the initial TV installation, the TV invited you
to press the OK key, and by doing so, the pairing was done.
When you switch off the TV, the pairing is stored. You can pair
up to 5 remote controls with this TV.
Pairing again
You can pair another remote control with this TV.
The method to pair a remote control is different for a remote
control already paired with another TV compared with a
remote control that is not paired yet.
• The remote control is paired with another TV
To pair, hold the Remote control close to the Philips logo
(about 10cm) and press the * Red and * Blue key at the
same time. A message will appear if pairing is successful.
• The remote control is not paired yet
To pair, hold the Remote control close to the Philips logo
(about 10cm) and press OK. A message will appear if pairing is
successful.
For retail
To pair a new - not yet paired - TV with a remote control
which is already paired with another TV, hold the Remote
control close to the Philips logo (about 10cm) and press the
* Red and * Blue key at the same time. A message will
appear if pairing is successful.
Batteries
The TV will notify you when the battery power of the remote
control is low.
To replace the batteries, open the battery compartment on
the keyboard side of the remote control.
1 - Use a toothpick or other small, blunt object and press the
small, square shaped release button to open the lid.
2 - Press the small lever next to the blue clip to release the
clip.
3 - Replace the old batteries with 2 type AAA-LR03-1.5V
alkaline batteries. Make sure the + and the - ends of the
batteries line up correctly.
4 - Press the blue clip down until it clicks.
5 - Reposition the battery cover and press it until it clicks.
Put the remote control down for about 15 seconds to calibrate
the pointer.
Remove the batteries if you are not using the remote control
for a long time.
Dispose of batteries according to the end of use directives.
In Help, press * List and look up End of use for more
information.
Cleaning
Your remote control is treated with a scratch-resistant coating.
To clean the remote control, use a soft damp cloth. Never use
substances such as alcohol, chemicals or household cleaners
on the remote control.
3.3
TV channels
Watching TV channels
Switch channels
To watch TV channels, press t TV. The TV tunes to the
TV channel you last watched.
24 TV / TV channels
Loading ...
Loading ...
Loading ...