Loading ...
Loading ...
Loading ...
INSTALLATION
Storage
www.stiebel-eltron-usa.com CK 150-1 / 200-2 Trend | 5
ENGLISH
Dust filter cleaning
- Clean the dust filter at regular intervals. The dust filter can
be pulled out from either side of the appliance.
You may need to detach the appliance from the wall mount-
ing bracket beforehand (See 11.1, “Wall mounting”, pg.
6).
D0000056455
7. Storage
f When not in use, keep the appliance in a dry place.
8. Troubleshooting
Problem Cause Remedy
The appliance does
not deliver the re-
quired heating output.
The dust filter is heavily
clogged.
Check and, if necessary,
clean the dust filter.
The appliance does
not heat up.
The temperature has
been set too low on the
appliance.
Check the temperature set
on the appliance.
Fuse or safety switch has
blown/tripped.
Check the circuit breaker in
your distribution panel.
Overheating. High limit
safety cut-out has re-
sponded.
Eliminate the cause (dirt or
obstructions at the air inlet
or outlet). The high limit
will reset automatically.
Fuse has blown.
Appliance cannot be re-
started. Contact Stiebel
Eltron.
If you cannot remedy the fault, notify your qualified contractor.
To facilitate and speed up your request, provide the number from
the type plate (000000-0000-000000).
SAVE THESE INSTRUCTIONS
INSTALLATION
9. Safety
Only a qualified contractor should carry out installation, commis-
sioning, maintenance and repair of the appliance.
9.1 General safety instructions
We guarantee trouble-free function and operational reliability only
if original accessories and spare parts intended for the appliance
are used.
9.2 Instructions, standards and regulations
NOTE:
Observe all applicable national and regional regula-
tions and instructions.
- Install the appliance in such a way that control equipment
cannot be touched by a person in the bath or shower.
- All electrical connection and installation work must be car-
ried out in accordance with the rules of your local power
supply utility, and relevant national and local regulations.
- Only mount the appliance on a vertical wall that is tempera-
ture-resistant to at least 194°F (90°C).
- Maintain minimum clearances to adjacent surfaces (See 14.2,
“Minimum clearances to hard surfaces”, pg. 8).
- Ensure wiring to the appliance is of adequate gauge.
- Mount the appliance no nearer than 4˝ (10 cm) from a wall
socket.
- Never install the appliance directly below a wall socket.
- When installing the heating appliance in rooms with a bath
or shower, observe the safety zone in accordance with the
details on the appliance type plate.
- Observe the type plate. The specified voltage must match the
mains voltage.
10. Appliance description
The appliance is a wall-mounted electric heater. It is particularly
suitable for heating rooms, such as work rooms, kitchens, bath-
rooms, wash rooms etc.
WARNING: Fire
A heater has hot and arcing or sparking parts inside.
Do not use it in areas where gasoline, paint or flam-
mable vapors or liquids are used or stored.
10.1 Standard delivery
The following are delivered with the appliance:
- Wall mounting bracket
Loading ...
Loading ...
Loading ...