Loading ...
Loading ...
Loading ...
5
POPPING INSTRUCTIONS
1. Make sure the popcorn maker is unplugged
before you do any of the following.
2. Clean the internal surface of the kettle with
warm, sudsy water, rinse well and dry with a
clean cloth. Wipe down inner and outer hous-
ing with damp cloth.
3. Main unit has 2 function switches as follows:
– Light/Warmer combination
– POP switch to turn heater and stirrer on
4. Hook the kettle onto the hanger of the
main unit.
5. Plug the power cord into an electric outlet.
6. Insert the internal plug into the socket (see
Figure 5, previous page).
7. Turn the light switch to the ON position and
the POP switch to the ON position. The stir-
rer will begin to rotate in the kettle. Let the
stainless steel kettle preheat about 1 to 2
minutes. Open lid and add oil (1 tablespoon
of vegetable, corn, peanut, or saf ower oil).
Immediately add ½ cup of corn kernels and
close lid to the kettle. Caution: Lid might be
hot – it is recommended to use an oven mitt.
NOTE: For your convenience, the lid to the kettle
is magnetized. Before adding oil or popcorn to
the kettle, lift kettle handle toward top of unit until
magnetic connection is made.
8. Popcorn starts popping out through the lid
after about 2 minutes. Yields up to 12 cups
per batch in less than 2½ minutes.
9. When unit is nished popping – you will no
longer hear the corn popping – immediately
turn POP switch to the OFF position and
rotate the roller bar of the kettle down to
release any remaining popcorn in the popper.
This will also stop the remaining popcorn
from cooking any further and avoid possible
burning.
10. The light/warmer may be left in the ON
position.
11. Keep POP switch OFF if the unit is not
continuously in use.
12. Keep only the Light/Warmer switch on.
13. Remove plug from power supply if the unit is
not being used.
14. Repeat steps 7 to 10 for continuous popping.
CLEANING AND
MAINTENANCE
It is strongly recommended to clean the kettle
frequently to avoid burning excess oil onto the
bottom of the inner pot.
After using the popcorn machine, use a wet cloth
to clean the main unit, main body and glass. It is
strongly recommended to wash and dry the tray
after each use to avoid any bacteria buildup.
Any other servicing should be performed by
an authorized service representative.
LIGHT/WARMER
The Light/Warmer bulb can be replaced with a
120V, 60W maximum bulb only.
QUICK CLEANING
PROCEDURE
Turn the POP control to OFF. Pour 5 to 8
ounces of water (NO detergent is necessary)
into inner pot. Switch to ON to boil the water and
let the stirrer turn in order to remove excess oil
stuck on the surface. After about 1 to 2 minutes
of boiling, pour out the water into a deep bowl or
sink to discard.
Or, remove the kettle and clean it with a scouring
pad. Do not immerse kettle or electrical plug in
water. CAUTION: THE KETTLE IS HOT.
Loading ...
Loading ...
Loading ...