Loading ...
Loading ...
Loading ...
8
Cleaning Load & Go™ Containers
(on some models)
IMPORTANT: Containers are not dishwasher-safe.
It is recommended that you rinse out the Load & Go
™ containers
when refilling, when changing detergent types or concentrations,
or when the washer will not be used for an extended period.
1. Pull the dispenser drawer out until it stops.
2. Lift out the Load & Go
™ containers.
3. Lift the fill lid and flush interior thoroughly with warm water.
4. Allow to air dry.
Nonuse and Vacation Care
Operate your washer only when you are home. If moving, or not
using your washer for a period of time, follow these steps:
1. Unplug or disconnect power to washer.
2. Turn off water supply to washer to avoid flooding due to water
pressure surges.
HELPFUL TIP: Attach a reminder note to the washer to turn
the water back on before washer's next use.
3. Clean the dispensers. See “Cleaning the Dispensers.”
Winter Storage Care
IMPORTANT: To avoid damage, install and store washer where it
will not freeze. Because some water may stay in hoses, freezing
can damage washer. If storing or moving during freezing weather,
winterize your washer.
To winterize washer:
1. Shut off both water faucets; disconnect and drain water inlet
hoses.
HELPFUL TIP: Attach a reminder note to the washer to turn
the water back on before washer’s next use.
2. Remove drain pump filter.
3. Put 1 quart (1 L) of R.V.-type antifreeze in drum and run
washer on Normal cycle for about 2 minutes to mix antifreeze
and remaining water.
4. Unplug washer or disconnect power.
Transporting Your Washer
1. Shut off both water faucets. Disconnect and drain water inlet
hoses.
2. If washer will be moved during freezing weather, follow
“Winter Storage Care” directions before moving.
3. Disconnect drain hose from drain system and from back of
washer.
4. Unplug power cord.
5. Place inlet hoses and drain hose inside drum.
6. Bundle power cord with a rubber band or cable tie to keep it
from hanging to the ground.
IMPORTANT: Call for service to install new transport bolts. Do not
reuse transport bolts. Washer must be transported in the upright
position. To avoid structural damage to your washer, it must be
properly set up for relocation by a certified technician.
Reinstalling/Using Washer Again
WARNING
Electrical Shock Hazard
Plug into a grounded 3 prong outlet.
Do not remove ground prong.
Do not use an adapter.
Do not use an extension cord.
Failure to follow these instructions can result in death,
fire, or electrical shock.
To reinstall washer after nonuse, vacation, winter
storage, or moving:
1. Refer to Installation Instructions to locate, level, and connect
washer.
2. Before using again, run washer through the following
recommended procedure:
To use washer again:
1. Flush water pipes and hoses.
2. Reconnect water-inlet hoses.
3. Turn on both water faucets.
4. Plug into a grounded 3-prong outlet or reconnect power.
5. Run washer through Heavy Duty/Power Wash cycle to clean
washer and remove antifreeze, if used. Use only HE
detergent. Use half the manufacturer’s recommended amount
for a medium-size load.
Loading ...
Loading ...
Loading ...