Loading ...
Loading ...
Loading ...
12
Verifying Proper Operation
WARNING
• Make sure that power to the electrical outlet is turned
off at the circuit breaker or fuse box and that the gas
is turned off at the gas supply valve before proceed-
ing.
• The rangetop must be properly grounded at all times
when electrical power is applied.
Prior to operating the rangetop, read the accompanying use
and care manual carefully.
1. Make sure all the
rangetop burner con-
trols are in the OFF
position.
2. Connect the power
cord to the electrical outlet.
3. Turn on power to the electrical outlet at the circuit
breaker panel or fuse box.
4. Gently push in and turn one of the burner control knobs
counterclockwise to the HIGH position. Verify that the
associated burner igniter sparks, then return the knob
to the OFF position. Repeat for all of the remaining
burner knobs.
5. Turn on the gas supply valve.
6. Perform the following ignition test for all of the burners,
one at a time:
• Push in and turn one of the control knobs counter-
clockwise to the HIGH position. Only the igniter for
the selected burner will spark. It may take up to four
seconds for the gas to ignite, at which time the ignit-
er will stop sparking. If ignition does not occur within
four seconds, turn the knob to the OFF position, wait
for at least five minutes to allow any gas to dissipate,
then repeat the test.
• Once the burner lights, the control knob can be rotat-
ed counterclockwise from HIGH to LOW to adjust the
flame height progressively.
• When the unit is installed properly, the flame will be
steady. It will also have
a sharp, blue inner cone
that will vary in length
proportional to the
burner size. The flame
will be reduced by the
Smart Flame™ feature
under the grate fingers
to increase grate life.
NOTE: If the rangetop does not operate properly, follow
these troubleshooting steps:
• Verify that power and gas are supplied to the rangetop.
• Check to make sure that the power plug is connected
to the electrical outlet and that power is turned on at
the circuit breaker panel or fuse box.
• Check to make sure that all burner parts are properly
seated.
• If the burner continues to spark after ignition without
stopping, have a licensed electrician check the electri-
cal outlet for proper grounding or reversed polarity.
• Repeat the burner ignition test.
If the appliance still does not work, contact Dacor
Distinctive Service at (800) 793-0093 ex 2822. Do not
attempt to repair the appliance yourself. Be sure to have
the model and serial numbers available when you call. See
the inside cover for location.
Dacor is not responsible for the cost of correcting problems
caused by a faulty installation.
Removing the Rangetop for
Repair
To remove the appliance for repair, perform the installation
process on the previous pages in reverse order.
Normal Flame
Appearance
Installation Instructions
OFF HIGH LOW
Loading ...
Loading ...
Loading ...