Loading ...
Loading ...
Loading ...
Time display
Before the program starts, the time
display shows the runtime of the
selected program in hours and minutes.
The remaining runtime is displayed
during the program.
Symbols will appear to indicate the
stage of the program:
1 Pre-wash
8 Main wash
% Interim rinse
( Final rinse
G Drying
O End
The time that is displayed may vary for
the same program. It depends on the
temperature of the incoming water, the
reactivation cycle and the quantity of
dishes.
When a program is selected for the first
time, the display shows an average
program runtime for warm water.
Standby
A few minutes after the last button is
pressed or a few minutes after the end
of the program the dishwasher will
switch to Standby mode to save
energy. The display and the indicator
lights are turned off and only the
Start/Stop indicator light flashes slowly.
^
Press any button to turn the display
back on.
If you do not turn off the dishwasher
after the program ends, it it will
automatically turn off completely after a
few minutes in Standby mode (see
"Settings - Optimize Standby).
If Refill salt, Refill rinse aid or a fault
is displayed during a program, the
dishwasher will not switch to
Standby mode.
The refill messages can be turned
off to let the dishwasher go into
Standby mode without first refilling
(see "Settings - Refill messages").
However, fault messages cannot be
turned off.
Use
37
Loading ...
Loading ...
Loading ...