Loading ...
Loading ...
Loading ...
33
1.6 Cu. Ft. Over-the-Range Microwave
www.insigniaproducts.com
Step 4: Option C - Attach the mounting plate to the wall
1 Remove the rear wall template.
2 Remove the mounting plate from the back of your microwave using a Phillips screwdriver.
3 Insert the toggle bolt(s) through the front of the mounting plate into the hole(s) that are not going into a stud,
and then attach the toggle wings ¾" onto each bolt. Hold your mounting plate up to holes in your wall to
identify the correct position.
4 Place the mounting plate against the wall and insert the toggle wings into the holes you drilled in the drywall.
Pull the mounting plate away from the wall to help tighten the toggle wings.
Note
The top of the mounting plate is indicated with an arrow. The mounting plate’s
hooks are on the front.
Note: Depending on
your stud locations, your
installation may look
different. You should
insert toggle bolts into
drywall and wood screws
into studs.
Bolt
Wing
Mounting plate
Loading ...
Loading ...
Loading ...