Loading ...
Loading ...
Loading ...
9
Operation
INSTALLATION CHECK LIST BEFORE OPERATION
:
1. Have all packing materials and tape been removed from the interior and exterior of the refrigerator?
2. Have the installation instructions been followed, including connecting the machine to electricity?
3. Has proper grounding been installed for the refrigerator?
4. Has the machine been leveled?
5. Is there a clearance of at least 2 to 3” at the rear for proper air circulation?
USING YOUR CONTROL PANEL:
This refrigerator has a temperature range
from 34°F to 50°F.
POWER BUTTON: Press and hold down for three seconds to power your unit on. Once pressed
the “Run” indicator light will illuminate to indicate the unit is on and running. Press and hold for
three seconds again and the unit will power off and the “Run” Indicator light will turn off.
INCREASING THE TEMPERATURE: To increase the temperature, press this button to raise the
temperature by one (1) degree increments.
DECREASING THE TEMPERATURE: To decrease the temperature, press this button to lower the
temperature by one (1) degree increments.
INTERIOR LIGHT: Press this button to alternate between the two internal light colors: blue and
white. Please refer to the “Internal Light” section on the next page for further details.
NOTE: Pressing and holding the increase and decrease temperature buttons at the same time will switch the temperature
display from °F to °C.
TIP: If you powered off the unit, please wait at least five (5) minutes before powering it back on.
WARNING: Allow at least 24 hours for your refrigerator to run before use to allow the temperature to acclimate.
Whether your refrigerator can reach the actual set temperature depends on the ambient environmental conditions.
Loading ...
Loading ...
Loading ...