Loading ...
Loading ...
Loading ...
EdgeStar Kegerator 6
Installing the Casters
This unit comes with four casters. These are an optional accessary to
assemble if you would like to make the unit more mobile. To install the
casters:
1. Remove the four leveling legs from the bottom of the unit.
2. With the contents inside the cabinet removed, set the beer dispenser
on its side.
3. Screw in the caster to attach it to the cabinet.
4. With all four casters tightened evenly, stand the unit in an upright
position.
OPERATION
Installation Check List before Operation
1. Have all packing materials and tape been removed from the interior
and exterior of the kegerator?
2. Have the installation instructions been followed, including connecting
the machine to electricity? And has proper grounding been installed for
the kegerator?
3. Has the machine been leveled?
4. Is the kegerator in a site where the ambient temperature is between
50º F and 95º F all year round?
Using the Temperature Control Panel
This kegerator has one control knob located on the left of the inside of the
cabinet. Turning the knob to the right or left will make the unit colder or
warmer respectively; 1 being the warmest and 6 the coldest.
WARNING: Kegerator should only be set to the coldest setting (6) for
short periods of time while dispensing. If the kegerator is set to the
coldest setting for an extended period of time, your keg will freeze. For
keg storage, we recommend setting the knob between 4 and 5.
Note: Whether your
kegerator can reach cooler
temperature depends on the
ambient environmental
conditions.
Caution: If you powered off
the unit, please wait at least
5 minutes before powering it
back on.
Note: Allow the
refrigerator to stand in
an upright position for
24 hours before turning
on the power. This will
ensure that the coolant
has settled.
Loading ...
Loading ...
Loading ...