Faber 6059892 Pro Magnum Baffles

User Manual - Page 7

For 6059892.

PDF File Manual, 14 pages, Read Online | Download pdf file

6059892 photo
Loading ...
Loading ...
Loading ...
Version 04/08 - Page 7
Light On/Off Button ( L )
On/Off switch for the halogen lights. Move the switch to "1"
to turn the light ON and to "0" to turn it OFF.
Blower On/Off Button ( M )
On/Off switch for the blower. Move the switch to "1" to turn
the blower ON and to "0" to turn it OFF.
Blower Speed Button ( V )
Speed control for blower. Move the switch to position 1 for
LOW Speed, 2 for MEDIUM speed and 3 for HIGH speed.
For Best Results
Start the rangehood several minutes before cooking to develop
proper airow. Allow the unit to operate for several minutes
after cooking is complete to clear all smoke and odors from
the kitchen.
Cleaning
The stainless steel grease lters should be cleaned frequently
in hot detergent solution or washed in the dishwasher. Clean
exterior surfaces with a commercially available stainless steel
cleaner. Abrasives and scouring agents can scratch stain-
less steel nishes and should not be used to clean nished
surfaces.
USE AND CARE INFORMATION
This rangehood system is designed to remove smoke, cooking
vapors and odors from the cooktop area.
Rangehood Control Panel
The control panel is located on the right-hand side under the
canopy. The position and function of each control button are
indicated in FIGURE 13.
FIGURE 13
WIRING DIAGRAM FOR 30" & 36" MODELS
Replacing the Halogen Lamps
Before you begin, make sure that the rangehood is turned
off and that the other lamps have had sufcient time to cool.
Halogen bulbs burn extremely hot and serious injury could
result from touching a hot bulb. To replace the lamp, the
bezel (A) around the lamp(C) must be removed as indicated
in FIGURE 14. This bezel (A) is held in place by two screws
(B). Remove the two screws and the bezel. Then remove
the lamp and replace with a new lamp. Once the new lamp
is in place, reinstall the bezel.
An alternative method to replace the lamps is to use a 1
1/4" suction cup (FIGURE 15). Attach the suction cup to
the bulb and pull rmly down on the bulb and replace with
a new lamp.
WIRING DIAGRAM FOR 48" MODEL
• This rangehood uses 20 watt Halogen Lamps.
FIGURE 14
FIGURE 15
Loading ...
Loading ...
Loading ...