Loading ...
Loading ...
Loading ...
©2019 Hestan Commercial Corporation
6
EN
PART REPLACEMENT - STORAGE DRAWER (AGSR30/36)
2. Lay the drawer face-down on a flat surface with a blanket or towel to protect the finish and the
handle. Remove the drawer face from the drawer box by removing 10 screws as shown below in
red. Remove 4 rubber bumpers as well.
1. To remove the drawer from
the box, press the release lever
(shown here in green) on each
side of the drawer to disengage
the slide (up on the left, down
on the right), then pull the
drawer all the way out.
4. The handle and endcaps can be transferred to
the new drawer face. Re-assembly is the reverse
process. It is recommended to install all screws
by hand, and NOT use a drill-driver or screw
gun. It is very easy to strip the threaded holes.
Reinstall the drawer by aligning the slides on
either side and push the drawer back into the
opening. You will hear the release levers click.
Open and close the drawer a few times to check
for proper function and alignment. Don’t forget
to re-install the rubber bumpers.
3. The drawer face should slide off as shown below.
The screws which secure the handle endcaps are
now accessible and can be removed.
P/N 030526 REV A