Loading ...
Loading ...
Loading ...
en
33
Connecting the appliance
After setting up the appliance, wait for at least 1 hour
before starting the appliance up. The oil contained in
the compressor may have been displaced into the
refrigeration system during transport.
Before starting the appliance up for the first time, clean
its interior (see section “Cleaning the appliance”).
It is imperative to connect the appliance to the water
supply before establishing the electrical connections.
Do not remove the transit locks from the shelves and
trays until the appliance has been installed.
Water connection
m Warning
Risk of electric shock and damage to property.
Disconnect the appliance from the electricity mains
before carrying out any work on the water connection.
The water connection must only be installed by a
qualified plumber and in accordance with local
legislation and regulations governing water quality.
A 3/4-inch water connection is required to connect the
appliance.
Connect the appliance to a domestic water supply with
the following specifications:
■ Minimum pressure: 1.0 bar
■ Maximum pressure: 8.0 bar
Contact a plumbing professional if you are uncertain
how to check the current water pressure.
m Caution
If the water pressure is more than 5.5 bar, a pressure-
reducing valve must be fitted; otherwise there is a risk
of water damage. If the water pressure is below
1.0 bar, the ice-maker will not function.
The water tap to which the connecting hose supplied is
connected should be easily accessible.
The appliance may only be connected to a cold water
pipe.
The taste and smell of the water can be improved by
installing the filter cartridge supplied. If doing so, take
note of the different connection specifications (see
section headed Water filter).
Note
After the appliance has been switched on, water can
drip from the water dispenser. After approx. 24 hours,
when the appliance has reached its operating
temperature, the dripping stops.
Connecting
m Caution
Risk of leaks and water damage.
Observe the following points:
■ Do not bend the connecting hose.
■ Tighten the screw socket by hand. Do not use pliers.
1. Screw the enclosed connecting hose onto the
thread of the device line.
2. Connect the screw socket to the water tap.
3. Loop or coil the connecting hose so that the
appliance can be moved away from the wall.
m Caution
Never bore or screw into the appliance!
Loading ...
Loading ...
Loading ...