Loading ...
Loading ...
Loading ...
www.PyleUSA.com www.PyleUSA.com
PLEASE NOTE
1. At initial start-up, keep the infrared light emission
window on the controller and the infrared light receiving
window on the main unit directly opposite of each other,
as shown by illustration above. This position is necessary
for remote controller to operate. Each valid operation of
the remote will 'beep' when starting.
2. Please charge it when the power is low . Just switch the
"ON/CHARGE" button to "CHARGE", and the indicator
will be in green and ashing, when it stops ashing and
keep in green, it means power has been fully recharged.
It takes about 3-4 hours to make it be fully charged.
3. If the remote controller does not work when the main
unit is charged and units are aligned at the proper
position, please replace battery CR2032 in the remote.
8 9
Cleaning & Maintaining
1. Use a soft barely damp towel to clean.
2. Store in a dry, well ventilated place.
3. Do not store in direct sunlight, or in an extremely hot
humid place.
Loading ...