Loading ...
Loading ...
Loading ...
43
ASSEMBLING COVER
The lid is supplied as accessory.
To install the lid
insert it in the
appropriate slots
as shown in the
drawing.
The Manufacturer will not be responsible for any inaccuracy resulting from printing or transcript errors con-
tained in this brochure. We reserve the right to carry out modifications to products as required, including
the interests of consumption, without prejiudice to the characteristics relating to safety or function.
Before closing the cover, to protect it from excessive temperature changes, always
wait until the burners or plates have completely cooled down.
Any spillages should be removed from the cover before opening it.
42
Lubricating the gas taps
If a gas tap becomes stiff, it should be dismantled, cleaned carefully with petrol and
smeared with a drop of special heat resistant grease.
The following operations should be carried but:
— disconnect the electrical power supply, close the gas supply tap from the mains or
cylinder.
— Remove the hob top plate by removing the corner screws and those under the
burners.
— Remove the two screws holding down the head flange.
— Remove the head flange and the retaining spring on the knob shaft.
— Remove the gas regulation cone, clean it with petrol and smear it with some heat
resistant grease, taking care not to obstruct any holes through which gas must pass.
— Re-assemble all the parts, making sure that the spring and the rotating axis of the
cone fitted to the knob shaft are correctly seated.
Aftercare
Before calling out a Service Engineer please check the following:
— that the plug is correctly inserted and fused;
— that the gas supply is not faulty.
If the fault cannot be identified:
switch off the appliance — do not tamper with it — call the Aftercare Service Centre.
The appliance is covered by a 12 month Guarantee giving free Aftercare Service.
Loading ...
Loading ...
Loading ...