Loading ...
Loading ...
Loading ...
What to do in the event of a fault en
21
Ice maker
--------
The ice maker is not functioning.
Ice cube production is switched off. Switch on ice cube production.
Freezer compartment is too warm. Set the temperature lower.
Ice cube container is not properly inserted. Insert ice cube container fully.
The ice maker is without power. Call Customer Service.
No water supply. Check water connection and contact technician if necessary.
Low water pressure. Only connect appliance to pipes with sufficient water pressure.
Kink in water hose. Turn off water supply, straighten out kink. Replace water hose if nec-
essary.
Too few or deformed ice cubes, water pressure lower than usual.
After switching on or removing many ice cubes, there will be too few
in the ice cube container.
It takes around 24 hours for an empty ice cube container to fill up.
Ice cube production stops even though the ice cube container is not
yet full.
Do not store the ice shovel on the ice in the ice cube container. Other-
wise, the sensor will not detect the actual fill level of the container.
Low water pressure. Only connect appliance to pipes with sufficient water pressure.
The water filter is blocked or needs to be replaced. Change water filter.
Freezer compartment is too warm. Set the temperature lower.
Water is leaking out of the appliance.
Water connection is not watertight. Check that the connections are fastened firmly and the water hose is
undamaged.
If the water hose is damaged, contact Customer Service and have it
replaced. Replacement must be performed by Customer Service or a
similarly qualified person.Use original parts supplied by the manufac-
turer only.
Loading ...
Loading ...