Loading ...
Loading ...
Loading ...
En
12
Adjusting the arm lifter height
If necessary, perform adjustment to match the cartridge being used.
Prepare as follows.
! Place a record on the turntable sheet.
! Remove the stylus cover and arm clamper while paying attention not
to touch the stylus tip.
! Pull up the lifter lever and move the tone arm onto the record.
Adjust the height by turning the screw while the arm
lifter is pushed down.
! Turing clockwise narrows the distance between the record and
stylus.
! Turing counterclockwise widens the distance between the record
and stylus.
The arm lifter height (the distance between the record and stylus when
the lifter lever is pulled up) is factory-adjusted in a range between
approximately 8 mm and 13 mm.
Arm lifter
* Turn the screw while pushing down this part.
Screw
Adjusting the arm height
1 Turn the [HEIGHT ADJUST] lock to unlock the lock.
Unlock
2 Push down the lifter lever and place the stylus on the
record, then adjust the [HEIGHT ADJUST] dial to make
the tone arm and record parallel.
Adjust so that the tone arm becomes horizontal
[HEIGHTADJUST]dial
Refer to the following table to adjust the [HEIGHT ADJUST] dial to match
the height to your cartridge size.
H
Cartridge size H
(mm)
[HEIGHT ADJUST]
dial
scale position
19 0
20 1
21 2
22 3
23 4
24 5
25 6
3 Turn the [HEIGHT ADJUST] lock to fix the height of
the arm.
After adjusting height of the arm, always turn the [HEIGHT ADJUST]
lock to fix the arm.
When scratch play is performed
To prevent stylus jumping, use the [HEIGHT ADJUST] dial to adjust the
arm height to match the play action.
Loading ...
Loading ...
Loading ...