Loading ...
Loading ...
Loading ...
6
Microwave Oven Care
General Cleaning
IMPORTANT: Before cleaning, make sure all controls are off and
the microwave oven is cool. Always follow label instructions on
cleaning products.
To avoid damage to the microwave oven caused by arcing due to
soil buildup, keep cavity, microwave inlet cover, cooking rack
supports, and area where the door touches the frame clean.
Clean with mild soap, water and a soft cloth or sponge, or as
indicated below.
Nonstick cavity coating (on some models): To avoid damage to
the microwave oven cavity, do not use metal or sharp utensils
or scrapers, or any type of abrasive cleanser or scrubbers.
Grease filter: mild soap and water or dishwasher.
Door and exterior: mild soap and water, or glass cleaner
applied to paper towel.
Control panel: sponge or soft cloth and water.
Stainless steel (on some models): mild soap and water, then
rinse with clean water and dry with soft cloth, or use stainless
steel cleaner.
Turntable: mild soap and water or dishwasher.
Rack(s) (on some models): mild soap, water and washcloth.
Dishwasher cleaning is not recommended.
Steamer vessel (on some models): mild soap, water and soft
brush or dishwasher.
Installing/Replacing Filters and Light Bulbs
NOTE: A filter status indicator (on some models) appears in the
display when it is time to replace the charcoal filter, and clean or
replace the grease filters. See “Settings” section to reset filter
status.
Grease filters: Grease filters are on the underside of microwave
oven. Clean monthly, or as prompted by filter status indicator.
Slide the filter away from the tab area, and drop out the filter.
To reinstall, place end of the filter into the opening opposite
the tab area, swing up the other end, and slide it toward the
tab area.
Charcoal filter: The charcoal filter is behind the vent grille at the
top front of the microwave oven. The charcoal filter cannot be
cleaned, and should be replaced about every 6 months, or as
prompted by filter status indicator. Remove two screws on the
vent grille, tilt the grille forward, lift it out, and remove filter. To
reinstall, place the filter into its slotted area – wire mesh side
up, replace vent grille, and secure with screws.
Cooktop light: The cooktop light is located on the underside of
the microwave oven, and is replaceable. Remove bulb cover
screw, and open the bulb cover. Replace bulb, close bulb
cover, and secure with screw.
Cavity light: The cavity light bulb is located behind the vent
grille at the top front of the microwave oven, under the bulb
cover, and is replaceable. Remove two screws on the vent
grille, tilt the grille forward, and lift it out. Open bulb cover and
replace bulb. Close bulb cover, replace vent grille, and secure
with screws.
Troubleshooting
First try the solutions suggested here or visit our website and reference FAQs (Frequently Asked Questions)
to possibly avoid the cost of a service call.
www.whirlpool.com
Microwave oven will not operate
Check the following:
Household fuse or circuit breaker
If a household fuse has blown or a circuit breaker has tripped,
replace the fuse or reset the circuit breaker. If the problem
continues, call an electrician.
Magnetron
Try to heat 1 cup (250 mL) of cold water for 2 minutes at 100%
cooking power. If water does not heat, try the steps below. If
microwave oven still does not operate, call for service.
Door
Firmly close door. On some models, if a packaging spacer is
attached to inside of the door, remove it, then firmly close door.
If a message about the door appears in the display, the door
has been closed for 5 minutes or more without the microwave
oven being started. This occurs to avoid unintended starting of
the microwave oven. Open and close the door, then start
the cycle.
Control
Make sure control is set properly. Make sure Control Lock is off.
Make sure Demo Mode (on some models) is off.
Arcing in the microwave oven
Check the following:
Soil buildup
Soil buildup on cavity walls, microwave inlet cover, cooking
rack supports, and area where the door touches the frame can
cause arcing. See “General Cleaning” in “Microwave Oven
Care” section.
Turntable alternates rotation directions
This is normal and depends on motor rotation at the beginning
of the cycle.
Display shows messages
A flashing “:” or “PF” means there has been a power failure.
Reset the clock.
A letter followed by a number is an error indicator. Call for
assistance.
Odor and smoke coming from microwave oven during
convection cooking (on some models)
This is normal for the first few convection cycles. The odor will
dissipate with repeated use.
Loading ...
Loading ...