Loading ...
Loading ...
Loading ...
5
EN
SAFETY AND WARNINGS
WARNING! TO REDUCE THE RISK OF FIRE, ELECTRIC SHOCK, OR INJURY TO PERSONS,
OBSERVE THEFOLLOWING:
z
Installation work and electrical wiring must be done by qualified person(s)
inaccordance with all applicable codes and standards, including fire-ratedconstruction.
z
Sufficient air is needed for proper combustion and exhausting of gases
through the flue (chimney) of fuel burning equipment to prevent back drafting.
Followthe heating equipment manufacturer’s guideline and safety standards such as
those published by the National Fire Protection Association (NFPA), andthe American
Society for Heating, Refrigeration and Air Conditioning Engineers (ASHRAE), and the
local code authorities.
z
When cutting or drilling into wall or ceiling, do not damage electrical wiring andother
hidden utilities.
z
Ducted fans must always be vented to the outdoors.
z
This unit must be grounded.
z
Wear gloves to protect against sharp edges.
Electricial
z
This appliance must be installed and connected to the mains power supply only by a
qualified person according to these installation instructions and in compliance with
any applicable local building and electricity regulations. Failure to install the appliance
correctly could invalidate any warranty or liability claims.
z
To comply with electrical safety regulations, the appliance must be plugged into
a socket near the appliance. The socket must be accessible, or have an accessible
isolating switch, to enable the end user to isolate the appliance from the power for the
purpose of internal cleaning or maintenance.
z
A power outlet should be within 750mm of the motor assembly and can either be on
the wall, behind the chimney or in the ceiling.
z
If the supply cord of this equipment is damaged, it must only be replaced by the
manufacturer, its service agent or similarly qualified person in order to avoid a hazard.
z
Ducting accessories are not supplied. All ducting must comply with local requirements
and building codes.
z
Electrical wiring must be done by qualified person(s) in accordance with all
applicablecodes and standards and the unit must be grounded.
z
Installation work and electrical wiring must be done by qualified person(s)
inaccordance with all applicable codes and standards, including fire-ratedconstruction.
Fire
z
WARNING: To reduce the risk of fire, use only metal ductwork. Do not use flexible
plastic ducting.
z
CAUTION: To reduce risk of fire and to properly exhaust air, be sure to duct air outside –
donotvent exhaust air into spaces within walls or ceilings or into attics, crawl spaces, or
garages.
z
To reduce the risk of fire and electric shock, install this range hood only with the
integral blowers supplied with this range hood.
z
The 8’ metal duct adapter supplied with this rangehood must be used for connecting
any ducting to this rangehood. Ducting should not be fitted onto the plastic blower
outlet.
Loading ...
Loading ...
Loading ...