Loading ...
Loading ...
Loading ...
English 7
Illustration 1:
Attach the handle to the frame of the pres-
sure washer. Align holes, insert bolts (B), and
tighten with knobs (A).
Illustrations on page 2
Illustration 2:
Mount the gun/hose storage (D) to the handle
and tighten with nuts (J) and washer (K).
Illustration 3:
Mount the nozzle holder (E) with enclosed
nylon rivets (C) to pressure washer
Illustration 4:
Place the quick connect nozzles (H) in the
nozzle holder (E).
Illustration 5:
Attach the wand (I) to the spray gun (G).
Push the wand (I) into the trigger gun (G) and
then thread the connection.
Assembling
OPERATING INSTRUCTIONS
STEP 1:
Pull the spring-loaded collar of the wand back
to insert your choice of quick connect nozzle.
Release the collar and push the nozzle until-
the collar clicks.
CAUTION
High pressure in nozzle area.
Risk of injury caused by improperly locked
nozzle.
■ Make sure you hear a "click" when inserting
the nozzle tip in to the wand.
■ Pull the nozzle to make sure it is seated
properly before operating your unit.
STEP 2:
Attach the high pressure hose to the trigger
gun.
CAUTION
Engine Shipped without oil. Before starting
engine, fi ll with oil. Do not over-fi ll. Do not run
the engine with a high or low oil level as this
can cause engine damage.
If you have further questions regarding the
engine, please refer to the engine manual
included with the unit.
STEP 3:
Check oil level. Oil level should always be
between the "FULL" and "ADD" or "MAX" and
"MIN" marks on the dipstick as shown in the
picture below.
Be sure the machine is level when checking
the oil level. (Refer to the engines operating
manual for seasonal grades).
We recommend that the oil be changed after
the fi rst 5 hours of use, then once every 50
hours.
FULL / MAX
ADD / MIN
Loading ...
Loading ...
Loading ...