Loading ...
Loading ...
Loading ...
Page:
6
User Manual:
REVERSING THE DOOR SWING:
Tools Required: Phillips head screwdriver, Flat blade screwdriver and Hexagonal spanner.
→ Start by ensuring the bar freezer is unplugged and empty.
→ Adjust the two levelling feet to their highest position.
→ To remove the door it is necessary to tilt the bar freezer backwards. Rest the freezer
against something solid to prevent it from slipping whilst removing the door.
→ All parts that are removed will be used when re-assembling the door hinge, so ensure
they are all kept safe .
→ DO NOT lay the bar freezer on its back or sides as this may damage the coolant system.
→ This is a two person proceedure.
1. Remove the plastic cover from the top door hinge.
2. Unscrew the three screws from the bottom bracket and remove the hinge bracket from
the opposite side and place aside.
3. Slide the freezer door down approximately 15cm and remove from the top hinge, lifting
the door away from the fridge.
4. Remove the two screws from the top bracket and replace the bracket using the same
screws on to the opposite side. Note: You will need to remove the plastic cover caps from
the opposite side rst.
5. Slide the freezer door back into the top hinge, ensuring that it is the correct way up. Then
screw the bottom hinge bracket into place, securing the door in place.
6. Fit the plastic cover caps and ensure that the door is aligned both vertically and
horizontally, before tightening the bottom hinge. Re-adjust the levelling feet.
Operating Your Bar Freezer
TEMPERATURE CONTROL
→ Your fridge has one control for regulating the temperature. The temperature control is
located at the rear, near the compressor.
→ Depending on your room’s ambient temperature, you may need to adjust the temperature
setting to achieve your desired temperature.
→ The number on the thermostat dial does not directly represent the temperature. Instead,
the larger the number is, the lower the freezer interior temperature will be. Dial position
1-2 will set your freezer to approximately -12°C, 3-4 will set your freezer to approximately
-15°C, and dial position 5-6 will set it to approximately -20°C.
Note: If the unit is unplugged, lost power, or turned o; you must wait 3 to 5
minutes before Restarting the unit.
→ If you choose to change the thermostat setting, adjust thermostat control by one
numerical increment at a time. Allow several hours for temperature to stabilize between
adjustments. Your rst use, you should set the thermostat to the maximum position of 6
for the rst 24 to 48 hours, afterwhich you can set it to the setting that best suites your
needs.
NOISE FROM YOUR BAR FREEZER
→ You may notice that your bar fridge makes some unusual noises from time to time. Most
of these are perfectly normal, but you should be aware of them!
→ These noises are caused by the circulation of the refrigerant liquid in the cooling system.
This is not a fault and will not affect the performance of your unit and is common with all
modern fridges.
Loading ...
Loading ...
Loading ...