Loading ...
Loading ...
Loading ...
49
en
Congratulations on your purchase of a Bosch vacuum
cleaner from the BHN series.
This instruction manual describes various BHN models,
which means that some of the equipment features and
functions described may not apply to your model. You
should only use genuine Bosch accessories, which
have been specially developed for your vacuum cleaner
to achieve the best possible vacuu
ming results.
Charging
!
Caution:
Before using the vacuum cleaner for the first time,
fully charge the batteries.
To charge the appliance, only use the charging cable
included with the appliance. The charging cable
must only be connected and operated as specified
on the rating plate. Do not charge the appliance at
temperatures below 0 °C or above 40 °C.
Fig.
1
To charge the vacuum cleaner, place it near to a so-
cket. The appliance can be left standing anywhere
in the room.
Plug the charging cable into the connection at the
rear of the appliance.
Plug the charging cable plug into the socket.
The charging indicator is lit up red when the appli-
ance is charging.
Once the battery is fully charged, the charging indi-
cator will light up blue and will then go out after a
few minutes. The battery will stop charging. Discon-
nect the appliance from the mains briefly to check.
The indicator will then light up blue again.
It is safe to leave the appliance connected to the
charging cable and socket even when it is fully char-
ged.
It is normal for the power adapter and vacuum clea-
ner to heat up and this is not a cause for concern.
Battery charging status indicator
The indicator shows the charging status of the battery.
Once the battery is fully charged, the indicator will
be lit blue.
When the indicator flashes, the battery must be re-
charged.
Vacuuming
Fig.
2
Slide the sliding switch to the required
position to set the suction power:
Position 1 1
For simple cleaning tasks
The appliance achieves the maximum run time at
this setting.
Position 2 2
Maximum suction power
For especially demanding cleaning tasks.
The appliance achieves a shorter run time at this set-
ting.
Crevice nozzle
For vacuuming crevices and corners, etc.
Fig.
3
Insert the crevice nozzle into the air intake opening
of the cordless vacuum cleaner as shown.
After using the appliance
Fig.
4
Switch off the appliance after vacuuming.
Emptying the dust container
In order to achieve the best possible vacuuming re-
sults, the dust container should be emptied after every
use.
Fig.
5
Press the release button to unlock the dust contai-
ner and then remove it from the motor unit.
Fig.
6
Use the handle to remove the motor protection filter
and foam filter from the dust container.
Empty the dust container.
Cleaning the filter
Fig.
7
Unlock the dust container. Remove the motor pro-
tection filter and foam filter from the dust container
(see fig.
5
and
6
)
Clean the motor protection filter and foam filter by
tapping out the dirt.
If the filters and the dust container are heavily
soiled, the dirt can be washed out.
Then wipe out the dust container with a dry cloth; al-
low the filters to dry completely before re-inserting
them.
Loading ...
Loading ...
Loading ...