Loading ...
Loading ...
Loading ...
Operation
Reversing the door
The side at which the door opens can be
changed, from the right side (as supplied) to
the left side, if the installation site requires.
Warning! When reversing the door, the
appliance must not be connected to the
mains. Ensure that the plug is removed from
the mains socket.
Note: Before you start laying the refrigerator
on its back in order to gain access to the
base, you should rest it on soft foam
packaging or similar material to avoid
damaging the backboard of the refrigerator.
To reverse the door, the following steps are
generally recommended.
1. Stand the refrigerator upright. Open the
upper door to take out all door racks (to
avoid racks damaged) and then close the
door.
2. Remove the Upper hinge cover (right) ①,
then remove the screws ② , and remove
part ③ . Put part ① just detached back to
plastic bag, place screws ② and part ③ at
side for use.
Note: Please hold the upper door by hand
during step 2 to prevent door dropping.
3. Remove the upper door and place it on a
smooth surface with its panel upwards.
Loose screws ① , and remove part ② ，
then install part ② to the left side with
screws ①.
4. Loose screws ① used to fix the middle
hinge ② and remove middle hinge ②. Then
remove the lower door.
5. Place the lower door on a smooth
surface with its panel upwards. Loose
screws ① , and remove part ② ， then
install part ② to the left side with screws ①.
6. Change screw hole covers on middle
cover plate from left to right (as shown in
figure below).
7. Place refrigerator flatwise, remove part
③ and then loose screws ④. Remove part
⑤, ② and part ①.
1
2
1
2
3
1
2
1
2
3
4
5
1
2
9
Loading ...
Loading ...
Loading ...