Loading ...
Loading ...
Loading ...
Page 21 | d108 & d110
ENGLISH
WARNING
WARNING! TURN OFF THE DOMINION™(s) AND ALL OTHER EQUIPMENT
IN THE SYSTEM BEFORE MAKING OR CHANGING ANY CONNECTIONS!
SYSTEM CONNECTION DIAGRAM 4:
Two Dominion™ Subwoofers in Stereo
to a Two-Channel Audio System
When connecting two Dominion™
subwoofers in stereo to a two-channel audio
system, you will assign one Dominion™ to
the le channel and the other Dominion™ to
the right channel.
Ideally, you will employ bass
management (crossover) features built
into your preamplier (if available), or
a dedicated active crossover (like the JL
Audio CR-1) to split the le and right
signals between your subwoofers and main
speaker amplier. In these scenarios, the
subwoofers will connect to the dedicated
subwoofer outputs of the active crossover
or preamplier. Connect the le output
of your preamplier to the “Line Input”
of the Dominion™ designated as the le
subwoofer. en, connect the right output
of your preamplier to the “Line Input”
of the Dominion™ designated as the right
subwoofer. Use good-quality audio
interconnect cables with RCA-type
connectors to make these connections.
If you are not using an external active
crossover or bass management built into
your preamplier, you can simply split
the audio signals at the outputs of your
preamplier, Y-adaptor cables (splitters).
en run an audio cable to each subwoofer
from these Y-adaptors. You will only use
one “Line Input” on each Dominion™ (le
or right).
In this scenario, you should engage the
low-pass lter on each Dominion™ to apply
low-pass ltering to the signal feeding each
subwoofer’s internal amplier. e signal
to the main speaker amplier will remain
full-range.
R
OUTPUTS
L
DOMINION™ REAR PANEL (RIGHT)
DOMINION™ REAR PANEL (LEFT)
off
|
on
LP Filter
PRE-AMPLIFIER
off
|
on
LP Filter
Y-ADAPTOR
R
R
L
L
INPUTS
SATELLITE AMPLIFIER
TO SATELLITE
SPEAKERS
(L) (R)
+
–
+
–
SPEAKER OUTPUTS
Y-ADAPTOR
Loading ...
Loading ...
Loading ...