Loading ...
Loading ...
Loading ...
27
Installation
STEP 16 Aligning the safety reversing sensors
The door will not close if the sensors have not been installed and aligned correctly.
When the lightbeam is obstructed or misaligned while the door is closing, the door will reverse and the
garage door opener lightswill flash ten times. If the door is already open, it will not close.
1. Check to make sure the LEDsin both sensors are glowing steadily.The LEDs in both sensors
will glow steadily ifthey are aligned and wired correctly.
The sensorscan be aligned by loosening the wing nuts,aligning the sensors,and tightening the wing
nuts.
Green LED
Amber LED
Wing Nut
SENDING SENSOR
RECEIVING SENSOR
(invisible light beam)
If the receiving sensor is in direct
sunlight, switch it with sending sensor so
it is on the opposite side of the door.
IF THE AMBER LED ON THE SENDING SENSOR IS NOT GLOWING:
1. Make sure there ispower to the garage door opener.
2. Make sure the sensor wire is not shorted/broken.
3. Make sure the sensor has been wired correctly:white wires to white terminal and white/black
wires to grey terminal.
RED
WHITE
WHITE
GREY
3
2
1
IF THE GREEN LED ON THE RECEIVING SENSOR IS NOT GLOWING:
1. Make sure the sensor wire is not shorted/broken.
2. Make sure the sensors are aligned.
1
2
STEP 17 Ensure the door control is wired correctly
If the door control has been installed and wired correctly,a message will display on the Smart Control
Panel screen.
Loading ...
Loading ...
Loading ...