Loading ...
Loading ...
Loading ...
Rinse aid system en
27
1. Press the catch on the lid of the
dispenser for rinse aid and lift
.
1
2
2. Add rinse aid up to the max mark.
max
3. If rinse aid spills out, remove it
from the tub.
Spilled rinse aid can cause ex-
cessive frothing during the wash
cycle.
4. Close the lid of the dispenser for
rinse aid.
a The lid clicks into position.
Setting the amount of rinse
aid
If there are streaks or water marks on
tableware, change the amount of
rinse aid.
1. Press .
2. To open the basic settings, press
for 3 seconds.
a The display shows H:xx.
a The display shows .
3. Press repeatedly until
the display shows the value set at
the factory r:05.
4. Press or repeatedly until the
right amount of rinse aid has been
set.
– A low setting adds less rinse aid
during the wash cycle and re-
duces streaking on tableware.
– A higher setting adds more
rinse aid during the wash cycle,
reduces water marks and im-
proves the drying result.
5. To save the settings, press
for 3 seconds.
Switching the rinse aid sys-
tem off
If you find the rinse aid refill indicator
irritating, e.g. when using combined
detergents with a rinse aid compon-
ent, you can switch the rinse aid sys-
tem off.
Tip:The function of rinse aid is lim-
ited with combined detergents. You
will generally get better results using
rinse aid.
1. Press .
2. To open the basic settings, press
for 3 seconds.
a The display shows H:xx.
a The display shows .
3. Press repeatedly until
the display shows the value set at
the factory r:05.
4. Press or repeatedly until the
display shows r:00.
5. To save the settings, press
for 3 seconds.
a The rinse aid system is switched
off and the rinse aid refill indicator
is deactivated.
Loading ...
Loading ...
Loading ...