Loading ...
Loading ...
Loading ...
First, loosen and remove the four screws
from the cross bars. Then interlock cross
bars A and B. Be sure to align the four
holes in the bars with those on the flange
of the outer tube. Secure the flange to the
bars with the four screws.
Loosen and remove the height adjustment
collar from the top of the inner tube. Slide
the base decorative cap down over the
assembly. Replace the height adjustment
collar on top of the inner tube. Pull the
inner tube out from the outer tube to
adjust the tube to the desired height and
tighten the collar.
If necessary, slightly loosen the set screw
by turning it anticlockwise. Slide the
switch box down over the inner tube and
tighten the set screw. Make sure the set
screw is tightly secured.
Blade and grill
Unscrew the guard mounting nut from the
front of the motor housing by rotating it
anticlockwise.
Position the rear grill against the front of
the motor housing with the handle at the
top, ensure that the locating pegs on the
motor housing are engaged correctly in
the holes of the rear grill.
Tighten the guard mounting nut
clockwise; do not to over tighten.
Push the fan blade onto the motor shaft,
locating the slot at the back of the blade
on the drive pin that passes through the
motor shaft. Tighten the blade cap by
turning it anticlockwise.
Position the front grill against the rear grill
so that the holes in the rims that accept
the small nut and bolt are in line. Insert
the bolt through the holes and screw on
the nut. Do not fully tighten at the stage.
Push the grill retaining clips into position
ensuring that they engage correctly on
the rim of the grill.
Fully tighten the small nut and bolt that
passes through the rim of the grill.
Assembly
Loading ...
Loading ...
Loading ...