Loading ...
Loading ...
Loading ...
Troubleshooting en
29
3.
Hook the rear retainers with the hook into the top
hole and push them into the bottom hole .
22.3 Attaching the rails
Notes
¡ When hanging the rails, ensure that the sloping
edge is at the top of the rail.
¡ The rails fit both the left- and right-hand sides.
1.
Set the rear rail at an angle, hooking it into the re-
tainers at the top and bottom .
2.
Pull the rail forwards .
3.
Hook in the rail at the front and press it down .
23 Troubleshooting
You can rectify minor faults on your appliance yourself.
Read the troubleshooting information before contacting
after-sales service. This will avoid unnecessary costs.
WARNING‒Risk of injury!
Improper repairs are dangerous.
▶
Repairs to the appliance should only be carried out
by trained specialist staff.
▶
If the appliance is defective, call Customer Service.
WARNING‒Risk of electric shock!
Incorrect repairs are dangerous.
▶
Repairs to the appliance should only be carried out
by trained specialist staff.
▶
Only use genuine spare parts when repairing the
appliance.
▶
If the power cord of this appliance is damaged, it
must be replaced by the manufacturer, the manufac-
turer's Customer Service or a similarly qualified per-
son in order to prevent any risk.
23.1 Malfunctions
Fault Cause and troubleshooting
The appliance is not working. The circuit breaker is faulty.
▶
Check the circuit breaker in the fuse box.
There has been a power cut.
▶
Check whether the lighting in your kitchen or other appliances are working.
"Sprache Deutsch" appears in
the display.
There has been a power cut.
▶
Implement the settings for the initial configuration.
→"Carrying out the initial configuration", Page13
The operation does not start or is
interrupted.
Malfunction
▶
Call the after-sales service.
→"Customer Service", Page31
Different causes are possible.
▶
Check any notifications that appear in the display.
→"Displaying information", Page14
Appliance does not heat up and
"Demo mode is switched on" ap-
pears in the display.
Device is in demo mode.
1.
Briefly disconnect the appliance from the power supply by switching the cir-
cuit breaker in the fuse box off and back on again.
2.
Switch off demo mode within three minutes in the
→"Basic settings", Page22.
There has been a power cut.
▶
Open and close the appliance door once after a power failure.
a The appliance is checked and is ready to use.
Loading ...
Loading ...
Loading ...