Loading ...
Loading ...
Loading ...
Installation Instructions
10
I
nstallation Instructions
Connecting water supply hose
Step1 : Check rubber seal in the inlet hose.
Two rubber seals are supplied with the water inlet
hoses.
They are used for preventing water leaks.
Make sure the connection to tap is sufficiently
tight.
The dryer must be connected to the cold water tap using the new water supply hose. Do not use old
hoses.
Periodically inspect and replace hoses if bulges, kinks, cuts, wear, or leaks are found.
Note
• Water supply pressure must be between 100 kPa and 1000 kPa (1.0 - 10.0 kgf / cm
2
).
• Do not strip or cross-thread when connecting inlet hose to the valve.
• If the water supply pressure is more than 1000 kPa, a decompression device should be installed.
• Periodically check the condition of the hose and replace the hose if necessary.
Hose
connector
Y connector
Y connector
Short
hose
Long
hose
AB
Rubber
seal
Note
• After connecting inlet hose to water tap, turn on
the water tap to flush out foreign substances
(dirt, sand or sawdust) in the water lines.
Let water drain into a bucket, and check the
water temperature.
Step2 : Check the installation environment.
A type
-. When using both washer and dryer with one
water tap.
Assemble Y connector and short hose.
Connect the female part of the short hose to the
water tap.
Connect the male part of Y connector to the
female part of the long hose.
Connect another male part of Y connector to the
female part of the inlet hose of washer.
B type
-. When using only the dryer from one tap.
Connect the female part of the long hose to the
water tap.
• Connect the water supply hoses to the COLD
water tap tightly by hand and then tighten another
2/3 turn with plier.
Loading ...
Loading ...
Loading ...