Loading ...
Loading ...
Loading ...
6
6. INSTALL ADAPTER
Remove adapter from inside hood.
Using both no. 8 x 3/8” zinc-plated screws from parts bag,
assemble the adapter on the top of the hood.
Seal all joints with metal foil duct tape to eliminate air
leaks.
HJ0069
MOUNTING SCREW LOCATIONS
7. INSTALL WOOD MOUNTING STRIP (IF NOT USING WALL EXTENSION)
NOTE: If range hood is installed with optional wall extension, refer to the instructions sheet included
with the wall extension for wood mounting strip location.
1. Proper structural support is required to accommodate the weight of the hood. Construct the wall
framing using minimum 2" x 4" lumber.
2. Mark the center location of the hood.
3. Measure and mark a level line on wall above cooktop location for the wood mounting strip (see
illustration on page 4). Install 2" x 4" blockings between wall studs where mounting strip will be
installed. Refer to illustration below.
4. Remove wood mounting strip from back of hood.
5. Position the wood mounting strip on the wall and secure to the wall studs and blockings using
4 no. 10 x 2’’ flat head screws (included in parts bag).
CAUTION
Due to the weight of this hood, ensure that the wood strip is attached to all of the
available studs and blocking; not into the wall alone.
HD0482A
Existing
Wall Studs
2" x 4"
Blocking
Back of Hood
Wood Mounting
Strip
14¼"
15
1
⁄8"
16"
18"
Loading ...
Loading ...
Loading ...