Loading ...
Loading ...
Loading ...
Replacing The Rock/Log Set And Light Bulbs
FIG 1
FIG 4 FIG 5 FIG 6
FIG 2 FIG 3
TO CHANGE LOG/ROCK SET (NOTE: MAKE SURE FIREPLACE IS TURNED OFF AND HAS BEEN UNPLUGGED
FROM ELECTRICALOUTLETBEFOREATTEMPTINGTOCHANGETHELOG/ROCKSET):
1. Place fireplace on a flat, level surface (FIG 1).
2. Remove 3 screws located on each side of glass face of fireplace (FIG 2 and FIG 3).
3. Remove screws that attach the log/rock set to the front of fireplace (FIG 4).
4. Replace with the desired set(log/rock) and re-assemble new set by inserting and tightening
screws(FIG 5).
5. Re-assemble glass face to fireplace by inserting and tightening screws on both side of glass
face (FIG 6).
This fireplace uses 2 clear 110 Volt, 40 Watt, E-12 socket base light bulbs (small base,
chandelier candle type bulbs). The access plate is located on thebottomof the unit. For
convenience, if one of the light bulbs burns out, it may be easier to replace both of the
light bulbs at the same time.
WARNING: Do not exceed 40 Watts per bulb. Use of higher rated bulbs may result in a
fire, causing property damage, personal injury or loss of life.
1 .Turn off the power to the unit, and unplug it from the electrical outlet.
2. Let the fireplace cool if it has been operating.
3. Look for the access plate with the gold printing onthe bottom ofthe unit.
4. Remove the 5 screws holding the access plate in position (FIG1).Once you have
removed the 5 screws, lift the access plate so the 3 positioning tabs come free of
their slots. Once you have removed the access plate you can see and access the two
40 watt chandelier bulbs (FIG 2).
14
Loading ...
Loading ...