Loading ...
Loading ...
Loading ...
Page 4 • JL Audio, Inc., 2017 Continued on Next Page
STEP 8
Pass a 1/4 - 20 x 1” Serrated Flange Head Bolt
through the hole in the Stainless Steel Cushion
Clamp, into the threaded insert in the speaker
pod. Do not fully tighten at this time.
Repeat the process for the second Stainless
Steel Cushion Clamp.
STEP 7
Align the speaker pod with the two lower
sections of the roll bar and the upper section
of the roll bar, as shown.
STEP 6
Lift the speaker pod into position, wrapping
the Stainless Steel Cushion Clamps around the
roll bar, as shown.
STEP 5
Place the speaker pod in the vehicle. Connect
the speaker cable to the terminal cup on the
back of the speaker pod.
STEP 4
Route speaker cable to the speaker pod
location, between the two lower sections of
the roll bar, as shown.
STEP 3
Align the holes in the Kick Panel Bracket with
the threaded inserts in the opposite side of the
speaker pod, and secure with a pair of 1/4 - 20 x
7/8” Hex Drive Flat Head Screws.
STEP 2
Place the speaker pod face down on a flat
surface. Pass a 1/4 - 20 x 1” Serrated Flange
Head Bolt through a hole in each Stainless
Steel Cushion Clamp. Thread an assembly into
each of the two upper threaded inserts on the
side of the speaker pod, as shown.
Align the other holes in the Stainless Steel
Cushion Clamps with the lower threaded
inserts, and fully tighten the bolts.
STEP 1
Pictured is the hardware needed for each
speaker pod. The following steps show the
installation procedure for the driver’s side only,
but the procedure is the same for both sides.
SB-POL-SLINGSPKR/M770 INSTR_SKU# 011484
Loading ...