Loading ...
Loading ...
Loading ...
19
DRIP TRAY
The drip tray located below the grill should be cleaned periodically to prevent buildup of debris.
NOTE: Allow the drip tray to cool before attempting to clean.
IMPORTANT: Do not leave the grill outside during inclement weather unless it is covered (cover sold
separately). Rain water can collect inside the grill, the grill cart or the drip tray if left uncovered. If the drip tray is
not cleaned after use and the grill is left uncovered, the drip tray will fill with water causing grease and water to
spill into the grill cart. We recommend cleaning and storing the drip tray after every use.
COOKING GRATES
The cooking grates can be cleaned immediately after cooking is completed and after turning off the grill. But,
exercise extreme caution because the grates will be very hot if you clean them immediately after cooking. Wear
a barbecue mitt and scrub the cooking grates with a damp cloth. If the grill is allowed to cool down, cleaning the
grates will be easier if removed from the grill and cleaned with a mild detergent.
HEAT CONTROL GRIDS
Washing the heat control grids after every use is not necessary but periodically it is suggested you wash them in
a soap and warm water solution. Do not clean the heat control grids immediately after use of the grill. Allow
them to cool. Use a wire brush to remove stubborn burned on cooking residue. Dry the heat control grids &
flame dividers thoroughly before you reinstall them in the cooking insert.
BURNERS
IMPORTANT: Gas control knobs should be in the “OFF” position and fuel line/source should be disconnected.
To reduce the chance of FLASHBACK, the procedure below should be followed at least once a month or when
your grill has not been used for an extended period of time.
Main Burner:
1. Clean main burner only when cool.
2. Remove your main burners from the grill by removing the pin holding the burner down and carefully lifting
the burner up and away from the gas valve orifice.
3. Wire brush entire outer surface of burner to remove food debris and dirt. Clean any clogged ports with a
stiff wire such as an open paper clip.
4. Inspect the burner for damage (cracks or holes) and if such damage is found, order and install a new burner.
5. After re-installation, check to insure that gas valve orifices are correctly placed inside ends of burner tubes.
Also check position of spark electrode.
Care & Maintenance
All cleaning and maintenance should be done only when grill is cool & with the fuel supply turned
off at the cylinder or source.
Loading ...
Loading ...
Loading ...