Loading ...
Loading ...
Loading ...
6
Press the metal shutoff plate on a flat surface to completely flatten bent flange.
HO0245
Using both screws previously removed, install the metal shutoff plate on top of the hood.
HD0415
5. INSTALL THE ADAPTER/DAMPER (ALL MODELS)
The wall duct must be roughed-in to properly interface with the hood. Before performing the installation, make sure the adapter fits easily
in the duct. If this hood replaces an existing hood, please note that location of the air exhaust can vary from one manufacturer to another.
FOR HORIZONTAL DISCHARGE ONLY:
Turn the hood over and remove the metal shutoff plate from the back of the hood, by
removing both retaining screws. Set screws aside.
Fold down the foldable flange of the adapter/damper. This flange must be at 90° from the
remaining flanges. See picture beside.
HD0112
HO0244
SCREW LOCATIONS
Using two no. 6 x 1/2’’ screws provided, secure the adapter/damper to the back of the hood.
Remove tape from damper flap.
Seal the adapter/damper to the hood using metal foil duct tape.
HO0178
TOP
BOTTOM
PIVOT
FOR VERTICAL DISCHARGE ONLY:
Using two no. 6 x 1/2” screws provided, secure the adapter/damper to the top of the hood.
Remove tape from damper flap.
Seal the adapter/damper to the hood using metal foil duct tape.
HO0179
SCREWS
PIVOT
Loading ...
Loading ...
Loading ...