10033716 User Manual

Loading ...

Wall Drilling and Bracket Fixing

As a rst step, proceed with the following drawings:

• A vertical line up to the ceiling or up to the upper limit, at the center of the area in

which the hood is to be tted.

(A) A horizontal line A at 1083–1183 mm above the cooker top.

(B) A horizontal line B at a 40-377 mm above the horizontal line A.

(C) A horizontal line C at a 118 mm below the horizontal line A.

Mark Points

Note: The specied values are [mm].

(1) Mark a point (1) on the horizontal line A, 60 mm to the right of the vertical

reference line. Repeat this step on the left side of the reference line and make sure

that the two points are at the same height.

(2) Mark a point (2) on the horizontal line B, 60 mm to the right of the vertical

reference line. Repeat this operation on the other side , checking that the two marks

are leveled.

(3) Mark a point (3) on the horizontal line C, 80 mm to the right of the vertical

reference line. Repeat this step on the left side of the reference line and on the

reference line itself. At the end you should have 3 points at the same height.

Fix the brackets (optional)

• Drill at the marked points (1), (2), (3) using a10 mm drill bit.

• Insert the Wall Plugs into the holes (1),(2), (3).

• Fix the hood xing bracket with 3 screws (5x50) at the horizontal line B.

• Fix the Chimney xing bracket with 2 screws (5x50) at the horizontal line C.

Loading ...

User Manual - Page 31