Loading ...
Loading ...
Loading ...
14
2. The chute deector on the top of the discharge chute
controls the height of the snow stream. To adjust the
height that the snow is thrown, squeeze the trigger on
the chute-deector handle, and then raise/lower the
chute deector. Release the trigger on the chute deector
handle to lock the chute deector in place (Fig. 17).
NOTE: ALWAYS position discharge chute deector at a safe
angle before engaging the auger. DO NOT throw snow any
higher than necessary.
LED Headlights
The LED headlights are located on the front of the snow
blower (Fig. 18).
1. To turn on the LED light, press the LED light button
(Fig. 19).
2. To turn o, press the LED light button again.
NOTE: After you have nished using your snow blower,
remember to turn OFF the light switch.
Operating Tips
mWARNING! Foreign objects, such as rocks, broken
glass, nails, wire, or string, can be picked up and thrown by
the snow blower, causing serious personal injury. Remove all
foreign objects from the area to be plowed before operating
the snow blower.
Snow is best removed as soon as possible after snow fall.
1. Keep the area of operation free of foreign objects that
can become thrown by the blades. Perform a thorough
inspection of the area since some objects may be hidden
from view by surrounding snow. If the snow blower hits
an obstruction or picks up a foreign object during use,
stop the snow blower, remove the battery, remove the
obstruction, and inspect the unit for damage. Repair or
replace any damaged part before restarting and
operating the unit.
2. Keep children, pets, and bystanders away from the area of
operation. Be aware that the normal noise of the machine
when turned on may make it dicult for you to hear
approaching people.
3. To clear an area, run unit in an overlapping series of paths.
For large areas, start in the middle and throw snow to
each side, so snow is not cleared more than once.
4. Note the wind direction. If possible, move in the same
direction as the wind so that the snow is not thrown
against the wind (and thus back into your face and on the
just cleared path).
5. Do not push the snow blower with excessive force. Do not
exceed the unit's intake or throw rate.
6. Some parts of the snow blower may freeze under extreme
temperature conditions. Do not attempt to operate the
snow blower with frozen parts. If the parts freeze while the
snow blower is in use, stop the snow blower, remove the
battery, and inspect for frozen parts. Free all parts before
restarting or operating the snow blower. Never force
controls that have frozen.
7. For larger areas, a denite pattern of operation is required
to thoroughly clean an area of snow. These patterns
will avoid throwing snow in unwanted places, a well as
eliminate the need for a second removal of snow (Fig. 20).
Pattern A: Throw the snow to the right or left side where
it is possible. For areas such as a long driveway, it is
advantageous to start in the middle. Plow from one end to
the other, throwing snow to both sides.
Pattern B: If the snow can only be thrown to one side of
the area to be cleared, start on the opposite side.
Fig. 17
Chutedeector
trigger
Fig. 18
LED lights
Fig. 19
LED light button
Loading ...
Loading ...
Loading ...