Loading ...
Loading ...
FITTING
Connect the GO Air into a
computer or USB 5V 1A
(or less) output device.
CHARGING CASE
OR
Charging
Fully
Charged
Place the earbud in the ear
canal and slightly rotate to
adjust for best fit.
Try all ear tips for best
fit and proper seal.
CAUTIONS
• Avoid extreme heat, cold, and humidity.
• Avoid dropping or crushing the earbuds.
• Wax may build up in the earbud tips, lowering the sound quality.
Carefully remove the wax with a cotton swab or other small tool to improve the sound quality.
• If you experience discomfort or pain, try lowering the volume or discontinuing use temporarily.
• If you experience regular discomfort while using this product, discontinue use and consult your physician.
• We recommend you treat your earbuds as you would a nice pair of sunglasses and keep them in safe location when not in use.
• The left or right earbud can be used independently for music and
phone calls. Simply choose one and take out of the case to connect.
• Only ONE Bluetooth device can be connected at a time. Turn off
Bluetooth on unwanted devices and turn on Bluetooth on chosen
device to connect.
QUICK TIPS
WARNING
Fully dry off the earbuds before
putting in the charging case to
avoid any damage to the case.
The earbuds are sweat/water
resistant but the case is not.
Shop products | Product alerts | Burn-in your headphones
JLab Audio + Burn-in Tool
JLABAUDIO.COM
Instructional videos at: JLABAUDIO.COM/MANUALS
TROUBLESHOOTING
Connection failure or earbuds disconnected from each other (Manual Reset)
1 Keep the earbuds in the charging case and forget “JLab GO Air” from your Bluetooth device settings.
2 Quick tap 7x on one earbud in charging case. Earbud blinks blue 3 times.
3 Quick tap 7x on other earbud in charging case. Earbud blinks blue 3 times.
4 Take both earbuds out of the charging case.
One earbud will be solid white and other will blink blue/white indicating ready to pair to your device.