Loading ...
Loading ...
Loading ...
Display Controls
The control panel, shown above, is at the middle of
the Refrigerator Chamber.
rEach time the power turns on, the display panel
will light everything for 3seconds, beep for 1
second, and then enter the normal display status.
rIcons are always lit (until the screen activates).
rThe display will activate the screen saver if no
button and no action is taken to open or close the
door for 60 seconds with the display on.
rAny button press or open door action will exit the
screen saver.
rPress the key in the screen saver state. Activate
the screen saver only. Do not change the settings.
rEach valid button press emits a short sound.
rThe corresponding temperature setting is
reflected in the display, and the setting takes effect
and is stored after 10 seconds of operation without
pressing the key.
Display
When you do not plan to use this appliance for a
period of time, you can save energy by entering
the standby state.
rTo enter standby mode, press and hold the
standby key for more than 3 seconds. The buzzer
will beep and the display board will show "OF".
rTo exit standby mode, press and hold the standby
key for more than 3 seconds. The buzzer rings will
beep.
NOTE: In standby mode, cooling will stop. If you do
notto use the appliance for a long time, take out
the wine, and unplug the unit.
Standby Mode
You can turn the interior light on or off by pressing
this button. After closing the door for 10 seconds,
the light will turn off automatically, so wine is not
exposed to light for too long.
A
B
C
D
E
I
G
F
Temperature Measure Change (°F / °C)
You can set the temperature you desire by pressing
the buttons " " or " ". When you press the button
for the first time, the LED readout will show the
previously set temperature. The temperature will
press the DOWN button.
NOTE:
rThe appliance doesn’t work properly if the set
temperature is higher than the ambient
temperature.
rThe temperature range is from 5°C(41°F ) to 18°C
( 64°F).
rThe temperature preset at the factory is12°C(54°F).
rWhen you set a temperature, you set an average
temperature for the whole cabinet. There may be a
2°C
( 36°F)to 3°C ( 37°F)variance between the top
and bottom shelves of the appliance.
Temperature regulation
Standby key
°F and °C Change key
Light On/ Off key
Temperature Indicator
Cancel alarm key
LOWER：Temperature control key -Down
LOWER:Temperature control key -Up
9
H
UPPER:Temperature control key -Down
UPPER:Temperature control key -Up
increase 1°C or 1°F each time you press the UP
button and will decrease 1°C or 1°F each time you
You can change the temperature display
setting from Fahrenheit to Celsius degrees by
pressing the marked ,and vice versa.
Loading ...
Loading ...
Loading ...