Loading ...
Loading ...
Loading ...
A
PREVENTING THE RISK OF CLOGGING OR DAMAGE:
IF THE PLUMBING IS NEW OR HAS NOT BEEN USED FOR A LONG TIME
TIME, BEFORE CONNECTING TO THE WATER SUPPLY CHECK THAT THE
WATER IS CLEAR AND FREE OF IMPURITIES, TO PREVENT DAMAGE TO THE
APPLIANCE. THE DISHWASHER MUST ALWAYS BE CONNECTED TO THE
THE WATER SYSTEM WITH NEW HOSES. OLD OR USED HOSES MUST
NEVER BE RE-USED.
LOCATION AND INSTALLATION
CONNECTING THE WATER SUPPLY
CONNECTING TO A WATER TAP
©2018 Hestan Commercial Corporation
7
(continued)
Firmly secure the hose by tightening the relative ring nut with your hands;
nish by tightening another 1/4 turn using a pair of plumbing pliers.
The dishwasher can be fi lled with water at a temperature of less than 140°F 60°C.
If the appliance is fi lled with hot water, washing times will be reduced by about
20 minutes, but effi ciency will be slightly impaired. Make the connection to the
domestic hot water tap using the same methods described for connecting the
appliance to the cold water tap.
• Recommended temperature: 49°C (120°F), max. 60°C (140°F).
• Recommended water pressure: 0.5 - 9 bar (7 -130 PSI).
A rubber hose connected to a sink spray may burst if installed on the
same pipes feeding the dishwasher. If your sink is fi tted with this
accessory, remove the hose and plug the hole.
Connect the inlet hose to a threaded 3/4” cold water tap tting the supplied lter.
If the pressure is too high, use a pressure reducer.
EN
Loading ...
Loading ...
Loading ...