Loading ...
Loading ...
5 Install baseplate.
Actual Size
Slides through same hole as wire.
Holds keypad and baseplate together
during installation.
6 Connect wire and 9V battery.
Lock will beep when
battery is connected.
7 Place battery in holder and tuck wires.
Any wire routing is acceptable as long
as wires will not be pinched by cover.
8 Install cover.
Actual Size
9 Install reinforcement plate and strike into door jamb.
1¹⁄₈"
(29 mm)
2³⁄₄"
(70 mm)
1"
(25 mm)
¹⁄₈" (3 mm)
Pilot Hole
¹⁄₈" (3 mm)
3" (76 mm) Deep
1¹⁄₂" (38 mm)
1" (25 mm)
Deep
Strike Cut-Out (not to scale)
Rotate 180˚ if
door stop is on
left side.
For maximum
security, install
reinforcement
plate.
Actual Size
Actual Size
Door Stop
Test Lock
a Lock (extend bolt).
1. Press the
Schlage button.
2. Rotate thumbturn
towards door edge.
Did bolt extend?
Yes. Lock is
installed correctly.
No. Lock is not installed
correctly. Remove lock and
reinstall. Pay close attention
to cam position in step 1.
For troubleshooting information, go to schlage.com/faqs-keypad.
CAUTION
Cam MUST be vertical!
Review Step 1!
Loading ...
Loading ...
Loading ...