Loading ...
Loading ...
Loading ...
www.tsicustomerservice.comA517
7
6 light levels can be selected:
Setting 1 -3 decrease in brightness with ickering;
Setting 4 -6 decrease in brightness without ickering.
TROUBLESHOOTING
Problem Root Cause Corrective Action
e heater is taking a
long time to reach desired
room temperature.
Location
Your unit should always be positioned on an inside wall with proper insula-
tion. e heater provides supplemental heating for up to 1000 sq/ in
conjunction with a primary heat source.
Location
e back and side of the heater should be greater than 6 inches away from
objects for proper air intake.
Use of surge protector/
extension cord.
Plug unit directly into the wall outlet.
Temperature will not
change.
Defective control panel
circuit board.
Replace control panel circuit board.
Heater does not turn on
but other functions work
ne.
Manual reset needed
Turn the POWER to “OFF” and unplug the unit from the wall outlet for 30
minutes. Aer 30 minutes plug the unit back into wall outlet, and operate as
normal. If the problem persist contact customer service.
Buttons do not work.
Defective control panel
circuit board.
Replace control panel circuit board.
Control panel does not
illuminate.
Defective control panel
circuit board.
Replace control panel circuit board.
Remote control is not
working when buttons are
pressed.
No batteries or battery
power.
Change the remote batteries.
Poor signal
Operate remote transmitter at a slow measured pace. Press the remote con-
trol buttons with an even motion and gentle pressure. Repeatedly pressing
buttons in rapid succession may cause the transmitter to malfunction.
Distance
Operate the remote at a distance less than 20 feet from the front of the
appliance; point the remote at the control panel.
CARE AND MAINTENANCE
• Clean the trim using a so cloth, slightly dampened with citrus oil based product and bu with a clean so cloth.
• DO NOT use brass polish or household cleaners as these products will damage the metal trim. Citrus oil based products can
be obtained at supermarkets or hardware stores.
• WARNING: Electrical outlet wiring must comply with local building codes and other applicable regulations to reduce the
risk of re, electrical shock and injury to persons.
• Warning: Disconnect power before attempting any maintenance or cleaning to reduce the risk of re, electrical shock or
personal injury.
Loading ...
Loading ...
Loading ...