Loading ...
Loading ...
Loading ...
8
To replace the reservoir on
the power handle, simply
slide it up towards the top
of the unit and slide the
reservoir release latch to
the locked position.
TIP USAGE
Pik Pocket
TM
Tip
The Pik Pocket
TM
Tip is specifically designed to deliver water
or anti-bacterial solutions deep into periodontal pockets.
To use the Pik Pocket
TM
Tip, set the unit to the lowest
pressure setting. Place the soft tip against a tooth at
a 45-degree angle and gently place the tip under
the gumline, into the pocket. Turn the unit on and
continue tracing along the gumline.
Tongue Cleaner Tip
To use the tongue cleaner tip, set to lowest pressure
setting, place tip in the center/middle of your tongue about
half way back and start the Water Flosser. Pull forward
with light pressure. Increase pressure to your liking.
Orthodontic Tip
To use the Orthodontic Tip, gently glide tip along gumline,
pausing briefly to lightly brush area between
teeth and all around orthodontic bracket, before
proceeding to the next tooth.
TROUBLESHOOTING YOUR WATERPIK
®
WATER FLOSSER
Toothbrush Tip
Place the toothbrush tip in mouth with the brush
head on the tooth at the gumline. The toothbrush
tip can be used with or without toothpaste.
Turn the Water Flosser on so the water flows through the tip. Using a light
pressure (bristles should not bend) massage the brush back and forth with
very short strokes-much like you would with a manual toothbrush.
Plaque Seeker
®
Tip
To use the Plaque Seeker
®
Tip, place the tip
close to the teeth so that the bristles are gently
touching the teeth. Gently glide tip along gumline, pausing briefly between
teeth to gently brush and allow the water to flow between the teeth.
Travel Water Plug
When traveling, place travel plug in unit to keep excess water
from draining out. NOTE: Do NOT run unit while travel
water plug is in unit.
Using Mouthwash and Other Solutions
Your Waterpik
®
Water Flosser can be used to deliver
mouthwash and antibacterial solutions. For ease of adding
other solutions remove the reservoir (see “When Finished”
section) and add from top opening on reservoir. If you
are adding additional water you may replace the reservoir
and fill reservoir fully with the fill door. After using
any special solution, rinse unit to prevent clogging by
partially filling reservoir with warm water and running
unit with tip pointed into sink until unit is empty.
Loading ...
Loading ...
Loading ...