Sun Joe SWJ802E-RM Electric Multi-Angle Pole Chain Saw 8 inch 6.5 Amp Green Certified Refurbished

User Manual - Page 16

For SWJ802E-RM.

PDF File Manual, 20 pages, Read Online | Download pdf file

SWJ802E-RM photo
Loading ...
Loading ...
Loading ...
15
Troubleshooting Table
Daily Checklist, Cleaning
and Storage
Daily Checklist
To help maintain your electric pole chain saw for optimum
performance, we recommend you complete this checklist prior
to each work session.
mWARNING! Do not plug in the power cord until you
have completed all of the daily checks.
Inspect for any visible damage to the chain, guide bar, or
motor housing.
Inspect the oil port and guide bar rails and clean them to
remove any debris.
Check the chain tension.
Check the chain teeth for sharpness.
Check the bar and chain oil level; ll with only new chain
oil specically formulated for chain saws.
NOISES: If you notice anything unusual, such as a vibration or
odd sound, shut the saw OFF immediately. Remove the power
cord and check the saw for any damage.
If you cannot nd the cause of the problem or are uncertain
what to do, then have the saw inspected by an authorized
Snow Joe
®
+ Sun Joe
®
dealer or call the Snow Joe
®
+
Sun Joe
®
customer service center at 1-866-SNOWJOE
(1-866-766-9563) before using it.
mCAUTION!
Remove the power cord and wait at least ve minutes for
the saw to cool before servicing or storing your unit.
If you drop the saw, carefully inspect it for damage. If the
guide bar is bent, the housing is cracked, the handle is
broken, or if you see any other condition that may aect
the saw’s operation, DO NOT USE the tool. Instead, have
it serviced at an authorized Snow Joe
®
+ Sun Joe
®
dealer or call the Snow Joe
®
+ Sun Joe
®
customer service
center at 1-866-SNOWJOE (1-866-766-9563).
Problems Corrective Action
The saw
motor fails
to start
Check that you installed the extension cord
properly into the pole saw power cord receptacle
and that you plugged the extension cord into a
live 120 V outlet.
Make sure that you fully depress and hold the
safety lock button before squeezing the ON/OFF
trigger switch.
The chain is too tight; re-tension.
The chain tension is too tight; re-tension.
The chain oil tank is empty; rell.
The lubrication holes are plugged; clean them out.
The chain tension is too tight; re-tension.
The guide bar or chain is damaged; inspect
and replace the damaged part.
The saw
runs, but
the chain
speed is
low
Bar and
chain
running
hot and
smoking
The saw
motor
runs, but
the chain
is not
turning
Loading ...
Loading ...
Loading ...