Loading ...
Loading ...
Loading ...
7. Maintenance
NOTE: This unit is sealed. The cover is not removable.
Due to the loudness of the alarm, we suggest that you place your
fingers over the sounder opening while testing your alarm.
Caution: Continuous exposure to the high sound level of this
alarm over an extended period of time may cause hearing loss.
Testing
To test the alarm, press the Test/Reset button. If the unit is operating
properly, you will hear 4 quick beeps – followed by 5 seconds of silence
– followed by 4 quick beeps. The red LED will flash along with the
beeps. Within several seconds the unit will return to monitor for CO.
Note: You do not need to press the Test button to take a CO
reading.
Maintenance Tips
To keep your alarm in good working order, you must follow these steps:
• Test the alarm once a week by pressing the Test/Reset button.
• Vacuum the alarm cover once a month to remove accumulated dust.
• Never use detergents or solvents to clean the alarm. Chemicals can
permanently damage or temporarily contaminate the sensor.
• Avoid spraying air fresheners, hair spray, paint or other aerosols near
the alarm.
• Do not paint the unit. Paint will seal the vents and interfere with
proper sensor operation.
!
Event Memory
If the unit has detected a CO concentration of 100ppm or greater,
the Green LED will flash every 10 seconds. Pushing the test button will
clear the Event Memory and initiate the test sequence.
Loading ...
Loading ...
Loading ...