Loading ...
Loading ...
Loading ...
7
3. Remove the cutting bar and chain from the mounting
surface (Fig. 5).
4. Remove the old chain from the bar.
5. Lay out the new saw chain in a loop and straighten
any kinks. THE SHARP SIDE OF THE TEETH MUST
FACE AWAY FROM YOU IN THE DIRECTION OF THE
CHAIN ROTATION INDICATED ON THE GUIDE BAR
. If the teeth face backwards,
turn the loop over (Fig. 6).
6. Starting at the tip, mount the chain drive links into the
bar groove, leaving a loop at the back of the bar. The
chain will loosely t until it is placed on the sprocket
(Figs. 7 & 8).
NOTE: Make certain of the direction of the chain
.If the chain is mounted
backwards, the saw will vibrate abnormally and will not
cut.
7. Hold the chain in position on the bar and place the loop
around the sprocket. Fit the bar ush against the mounting
surface so that the bar studs are in the long slot of the bar
and the adjusting pin is in the chain tension pin hole
(Fig. 9).
R
R
Fig. 4
Chain/sprocket end cover
R
Fig. 5
Cutting bar
Chain
Fig. 6
Chain rotation
Sharp cutting edge
Chain drive link
R
Fig. 7
Fig. 8
Loop
R
Fig. 9
Sprocket
Bar studs
Chain tension pin hole
(with adjusting pin)
Loading ...
Loading ...
Loading ...