Loading ...
Loading ...
Loading ...
16
11 Slide a brass compression nut, then a ferrule (sleeve), onto the water
supply line.
12 Push the end of the tubing into the water inlet valve as far as it will go
or ¼-inch, then slide the ferrule (sleeve) into the valve inlet and finger
tighten the compression nut onto the valve. Tighten another half turn
with a wrench. DO NOT overtighten.
13 Secure the water supply line to the back panel of your refrigerator with
a steel clamp and screw at the location shown
on the illustration.
14 Coil the excess water supply line (about 2-½ turns) behind the
refrigerator and arrange the coils so they do not vibrate or wear
against any other surface.
15 Turn on the water supply at the shutoff valve and tighten any
connections that leak.
16 Reconnect the refrigerator to the electric wall outlet.
17 To turn on the ice maker, lower the wire signal arm.
Important
It takes approximately 24 hours for the ice maker to begin
producing usable ice. Air in new plumbing lines may cause the
ice maker to cycle two or three times before making a full tray of
ice. New plumbing may cause ice to be discolored or have poor
flavor. Discard ice made during the first 24 hours.
1/4” tubing
1/4” compression nut
Water inlet valve
Ice Maker
Loading ...
Loading ...
Loading ...