Loading ...
Loading ...
Loading ...
4
AUS
Installation
Where to put your dryer
Place your dryer at a distance
from gas ranges, stoves,
heaters, or cooktops because
flames can damage the
appliance.
If you are going to install the
appliance under a work counter,
be sure to leave a 10 mm
space between the top and any
other objects on or above the
machine and a 15 mm space
between the sides and lateral
furnishings or walls. This is to ensure proper air circulation.
Ventilation
When the dryer is in use, there has to be adequate
ventilation. Make sure you put your dryer in an environment
that is not damp and has proper air circulation throughout.
Airflow around the dryer is essential to condense the water
produced during the washing, the dryer will not operate
efficiently in an enclosed space or cupboard.
If using the dryer in a small or cold room some
condensation will be experienced.
We do not recommend installing the dryer in a cupboard
because dangereous levels of heat can buildup! The dryer
must not be installed behind a loackable door, a sliding
door or a door with the hinge on the opposite side to that
of the tumble dryer in such a way that the full opening of
the tumble dryer door is restricted.
Water Drain
If your dryer is installed next to a drain the water can be
plumbed into this drain. This does away with the need to
empty the water container. If the dryer is stacked onto or
installed next to a washing machine it can share the same
drain. The dryer is supplied with a length of hose and this
must be used to drain the condensed water under certain
conditions.
If you are using a washing machine with a spin speed below
1100 rpm and drying loads of 7 kg or more and for energy
label test to AUS/NZS 2442 you must plumb out the water
or the container may fill before the clothes are dried. Follow
the instruction below. The height of the drain must be less
than 3 (1 m) from the bottom of the dryer.
Remove existing hose from position shown in picture A
and fit the supplied length of hose to location shown in
picture B.
! Make sure that the hose is not squashed or kinked
when the dryer is in its final location. The length of the
hose can be reduced if necessary to avoid this.
10 mm
15 mm
15 mm
2
H<1m
2
Fig. A
Fig. B
Electrical connections
Before plugging the appliance into the socket, check the
following:
Make sure your hands are dry.
The socket must have an earth connection.
The socket must be able to withstand the machines
maximum power output as indicated on the data plate (see
Description of the tumble dryer).
The power supply voltage must fall within the values
indicated on the data plate (see Description of the tumble
dryer).
The socket must be compatible with the machines plug. If
not, either the socket or the plug must be replaced.
Do not use extension cords.
The tumble dryer must not be installed in outdoor spaces,
even if sheltered. It may be very dangerous to expose this
appliance to rain and thunderstorms.
Once dryer installation is complete, the electric cord and
plug must be at hand.
The electric cord must not be bent or crushed.
If the plug is replaced is of the moulded type, it must be
disposed of in a safe way, DO NOT leave it where it can be
plugged into a scoket and cause electric shocks.
The electric cord must be regularuily checked and replaced
with a cord specifically designed for this dryer: it must then be
installed by an authorised technician only (see Assistance).
New or longer electric cords are supplied by authorised
delaers at a supplementary cost.
The manufacturer declines all reposnsibility for filaure to
observe these instructions.
CAUTION: If this appliance is supplied from an extension
cord or portable oulet device, the extension cord or portable
device must be positioned so that it is not subjected to
splashing or contact with moisture.
If the supply cord is damaged, it must be replaced by the
manufacturer, its servive agent or simlarily qulified persons in
order to avoid a hazard.
If in doubt about any of the above consult a qualified electrician.
Before you start using your dryer
Once youve installed your dryer and before you use it,
clean the inside of the drum to remove any dust that could
have accumulated during transportation.
Loading ...
Loading ...
Loading ...